Page 1 of 1

Laser cutter time

Posted: Thu Jun 08, 2017 11:00 pm
by jet
A few of us have laser cutters, not sure who else is set up to sell time. I can't have clients visit (borough rule on working from home studio) but I have a pickup with a cap and can pick up and drop off. My lasersaur has a 48x24" cutting bed, ~130W laser, and cuts between .1 and .03mm. I'm working out doing good rasters this weekend and will work up a rate chart.

Re: Laser cutter time

Posted: Sun Jun 18, 2017 3:21 am
by jet
Did some etching tests today and I am getting ready to sell services. Any suggestions for figuring out a good local rate? I can pick up stock and deliver finished product, I live 10min from Bakery Square and have a covered pickup.